Embedded Files
Batch Size: 10
Time Standard: 45
Drill press hoops (should be able to be found on To Be Assembled shelves in Workshop) through the Sharpie marks that were made. Use the metal bit and drill through to the second width.
Drill depth should be determined by how much it takes to get through to the second step on the metal bit.
Match the stained blanks with the same numbered ring. Place the hoop down on the jig wide side down. Then put the wood inside the ring.
Drill a pilot hole into the wood through the holes that you drill-pressed in the metal using a 1/8" bit (there are 2 on each side)
Careful not to blow out the side of the wood!
Careful not to blow out the side of the wood!
Grab your stainless steel #7x 1-5/8" screws
Put the screws in through the pilot holes. Again, careful to avoid blow-out. It can be tricky.
Next Stop: Handover to Fulfillment
Page updated
Google Sites
Report abuse