Machine Harvest Basket Rails
Machine Harvest Basket Rails
Embedded Files
First make sure you are using the right offset: Frank Offsets
Align the jig to the front left corner.
Load the file. Harvest Basket Rail Grooves 10.10.22
Insert the 1/8" Upcut Bit.
Zero the bit to the waste-board.
Insert rails in the machine.
Drive the machine so that the red line is overtop of the green line.
This shows the machine coordinates for the file. We want to make sure that the machine coordinates
This shows the machine coordinates for the file. We want to make sure that the machine coordinates
Now, look at the bit compared to the rail. It should be roughly centered.
If it is not, adjust the MDI.
If it is not, adjust the MDI.
When you close and re-open the file now, drive the red line over the green line.
This time, the bit should be more centered in the rail.
Repeat until you have it in a good position.
This time, the bit should be more centered in the rail.
Repeat until you have it in a good position.
Run the file.
Page updated
Google Sites
Report abuse