Phantom CNC Operation

Turn on air compressor

See Air compressor guide to learn more

1. press State

2. press "A"

press REF Point

press F7

Select Advanced 

Select " = "

(Make sure air compressor is on)

With the arow keys hover over the tool number you wish to calibrate

press enter to select (press enter again to deselect)

Press F1 to calibrate the selected tool(s)

Make sure vacuums are turned on before setting the Z 0 as this will  affect the accuracy of the following actions

jog the CNC Spindle to the front left (do not over correct and trip the E stop) making sure to leave enough space between the spindle and the XY Axis limit sensors

Select Handle

the handle set it to the Z axis and X100

Set a sheet of paper below the cnc router spindle

with the handle lower the cnc router spindle untill it is very close but not making contact

set it to x10 and keep loweing the CNC router spindle untill is just making contact with the paper

Select state

Select clear(F6)

Select Z Clear (F4)

Select Program

Select USB File (pressing program again will switch screens)

use the arrow keys to hover over the correct file and enter to select it

use the arrow keys to hover over the correct file and press F1 to load the file

jog the cnc to the center of the work area(some files jog backwards first) to prevent triping the Estop in case the cnc runs into a limit switch

Turn on CNC Vacuum

Turn on dust collector

Start Job